1. Cut the hose square with a Radiac wheel or a fine tooth hacksaw. It is necessary to wrap the hose tightly with masking or electrical tape and to cut through the tape. This helps to prevent the stainless braid from fraying.

2. Trim any frayed ends of the braid with sharp snips or diagonal cutters and remove the tape.

3. Slip the Econ-O-Fit collar over the end of the hose.

4. Lubricate the inside of the hose and the outside of the Auto-Mate nipple.

5. Push the Auto-Mate into the hose until it bottoms against the socket.

6. Tighten the Econ-O-Fit hose clamp.

7. Blow the assembly clean and pressure test before running the car.

All parts sold by MPS are for off road closed course use. They are not intended for use on public streets or highways.

Motorcycle Performance Specialties
5350 McIntosh Point #132 - Sanford, Florida - 32773
Phone: (407)330-9727 - Fax: (407) 322-8632
Sales E-Mail: sales@mpsracing.com